|
Prev 1 [2] 3 Next
|
ACT RS314I A10, 277VAC, 20A, SP, Single Feed-Thru Switch, Rocker Style, Ivory (Special Order) |
|
|
|
|
|
ACT RS314W A10, 277VAC, 20A, SP, Single Feed-Thru Switch, Rocker Style, White (Special Order) |
|
|
|
|
|
ACT Scope-Test2 PCC Dual Trace Oscilloscope Adapter Test UnitThe function of this device is to reduce the high voltage from an electrical source (up to 277 volts AC) to approximately one twentieth its original voltage while also allowing Powerline Control pulses to pass through to be viewed on a standard oscilloscope display. |
|
|
|
|
|
ACT TB100 120VAC, Wall-Box Mount Transmitter Base (keypad sold separately)This wall mounted transmitter sends powerline command signals to X10 and A10 Receiver Modules, which switch their designated loads. Signals are transmitted to Receiver Modules over existing AC power lines, so dedicated wiring for the system components is not necessary. Four keypad models can also send ALL LIGHTS ON and ALL UNITS OFF commands. |
|
|
|
|
|
ACT TB134 A10, 120VAC Maintained/Momentary 6-Channel Transmitter BaseThe TB134, TB234 and TB334 are A10 enhanced PCC transmitters that accept up to six dry contact inputs and transmit six unique powerline carrier addresses. Each of the six contact wire inputs corresponds to a standard code address (256 available) or extended code addresses (4,096 available). The addresses are configured by the user. Whether an OFF or an ON code is transmitted on contact closure will depend on which of two additional control wires is connected to the input contact. The TB transmitter can be push-button configured for inputs to be momentary or maintained. Output transmission is always polite. |
|
|
|
|
|
ACT TB234 A10, 208-240VAC Maintained/Momentary 6-Channel Transmitter Base w/DIN clipsThe TB134, TB234 and TB334 are A10 enhanced PCC transmitters that accept up to six dry contact inputs and transmit six unique powerline carrier addresses. Each of the six contact wire inputs corresponds to a standard code address (256 available) or extended code addresses (4,096 available). The addresses are configured by the user. Whether an OFF or an ON code is transmitted on contact closure will depend on which of two additional control wires is connected to the input contact. The TB transmitter can be push-button configured for inputs to be momentary or maintained. Output transmission is always polite. |
|
|
|
|
|
ACT TB300 277VAC, Wall-Box Mount Base Transmitter (keypad sold separately) |
|
|
|
|
|
ACT TB334 A10, 277VAC Maintained/Momentary 6-Channel Transmitter BaseThe TB134, TB234 and TB334 are A10 enhanced PCC transmitters that accept up to six dry contact inputs and transmit six unique powerline carrier addresses. Each of the six contact wire inputs corresponds to a standard code address (256 available) or extended code addresses (4,096 available). The addresses are configured by the user. Whether an OFF or an ON code is transmitted on contact closure will depend on which of two additional control wires is connected to the input contact. The TB transmitter can be push-button configured for inputs to be momentary or maintained. Output transmission is always polite. |
|
|
|
|
|
ACT TC184A Built to Order, A10, 120VAC 8-Button Transmitter Controller, Almond |
|
|
|
|
|
ACT TC284A Built to Order, A10, 208/240VAC, 8-Button Transmitter Controller, Almond |
|
|
|
|
|
ACT TC384A Built to Order, A10, 120VAC 8-Button Transmitter Controller, Almond |
|
|
|
|
|
ACT TD130 120VAC, Manual Transmitter w/lockThe TD130 and TD230 Keypad controls 16 addresses, but changing letter code switch allows control of any of the 256 address points. The TD130 and TD230 are packaged in a rugged metal case with a carrying handle. It has a keyed switch to lock out the keyboard for security purposes, plus an LED on the keypad to verify signal transmission. Often used by building maintenance engineers as a portable troubleshooting tool, the TD130 or TD230 can also reside on a desktop at a guard station, or in a maintenance office to provide backup or override of a programmed powerline control system. |
|
|
|
|
|
ACT TD140 120VAC, 64-Channel Load ControllerThe TD140 is a compact, manually operated, 64 channel X10 / A10 transmitter in a keyboard design, allowing ON/OFF control of room heating and air conditioning units and other electrical loads, and is expandable to control up to 256 separate electrical loads. Coded command signals from the TD140 are transmitted via existing AC power wiring to receiver switching modules. |
|
|
|
|
|
ACT TH104 120VAC, Hotel Room Controller, Card Switch Transmitter |
|
|
|
|
|
ACT TI103-RS232 A10, Computer 2-Way Interface to Powerline, RS232 Version, N. Amer.The TI103-RS232 is a power line carrier transceiver with an RS232 serial communications cable to connect to any IBM compatible computer. The standard model is available in 9600/19200 baud (switch selectable) or a Version 2 model in 2400/ 4800 baud (switch selectable). |
|
|
|
|
|
ACT TI103-RS232-RJ A10, Computer 2-Way Interface RS232 with Phone Plug |
|
|
|
|
|
ACT TI203-RS232 A10, Computer 2-Way Interface to Powerline, RS232 Version, Australia |
|
|
|
|
|
ACT TI213-RS232 A10, Computer 2-Way Interface to Powerline, RS232 Version, Euro |
|
|
|
|
|
ACT TI223-RS232 A10, Computer 2-Way Interface to Powerline, RS232 Version, UK |
|
|
|
|
|
ACT TI233-RS232-RJ A10, Computer 2-Way Interface, RS232 Version, Flying leads with Phone Plug |
|
|
|
|
|
ACT TK010 1 Button Keypad, All On/Off, IvoryThe TK010 and TK011 1-button keypads send ALL LIGHTS ON and ALL UNITS OFF commands to all appropriate Receiver Modules set to the same Letter Code as the TB controller. |
|
|
|
|
|
ACT TK011 1 Button Keypad, All On/Off, WhiteThe TK010 and TK011 1-button keypads send ALL LIGHTS ON and ALL UNITS OFF commands to all appropriate Receiver Modules set to the same Letter Code as the TB controller. |
|
|
|
|
|
ACT TK030 2 Button Keypad, 2 On/Off, Sequenced, IvoryThe TK030 and TK031 2-button keypads send ON and OFF command signals to two addresses. |
|
|
|
|
|
ACT TK040 4 Button Keypad, 3 On/Off Sequenced, 1 All On/Off, IvoryThe TK040 and TK041 4-button keypads send ON and OFF commands to three sequential addresses and ALL LIGHTS ON and ALL UNITS OFF commands to all appropriate Receiver Modules in the system set to the same Letter Code. |
|
|
|
|
|
ACT TK041 4 Button Keypad, 3 On/Off Sequenced, 1 All On/Off, WhiteThe TK040 and TK041 4-button keypads send ON and OFF commands to three sequential addresses and ALL LIGHTS ON and ALL UNITS OFF commands to all appropriate Receiver Modules in the system set to the same Letter Code. |
|
|
|
|
|
ACT TK050 4 Button Keypad, 3 On/Off Sequenced, 1 Dim Control, IvoryThe TK050 and TK051 4-button keypads send ON and OFF as well as DIM and BRIGHT commands to incandescent lighting controlled by appropriate PCC Receiver Modules capable of full-range dimming. By pressing the three topmost control rockers simultaneously, or in rapid sequence, all three addresses can be dimmed simultaneously by the 4th DIM/BRIGHT button. |
|
|
|
|
|
ACT TK051 4 Button Keypad, 3 On/Off Sequenced, 1 Dim Control, WhiteThe TK050 and TK051 4-button keypads send ON and OFF as well as DIM and BRIGHT commands to incandescent lighting controlled by appropriate PCC Receiver Modules capable of full-range dimming. By pressing the three topmost control rockers simultaneously, or in rapid sequence, all three addresses can be dimmed simultaneously by the 4th DIM/BRIGHT button. |
|
|
|
|
|
ACT TK060 4 Button Keypad, 4 On/Off Sequenced, IvoryThe TK060 and TK061 4-button keypads send ON and OFF command signals to four sequential addresses (such as D-14, D-15, D-16 and D-1, for example). |
|
|
|
|
|
ACT TK061 4 Button Keypad, 4 On/Off Sequenced, WhiteThe TK060 and TK061 4-button keypads send ON and OFF command signals to four sequential addresses (such as D-14, D-15, D-16 and D-1, for example). |
|
|
|
|
|
ACT TK134A A10, 120VAC, Rocker Style, Transmitter, Almond (Special Order)Most of the wall-Mount units are stocked in White (W) and Ivory (I), however, "Almond" is usually only available in large quantities, special order. Call for quote and lead-time. |
|
|
|
|
|
ACT TK134I A10, 120VAC, Rocker Style, Transmitter, Ivory |
|
|
|
|
|
ACT TK134W A10, 120VAC, Rocker Style, Transmitter, White |
|
|
|
|
|
ACT TK184A Built to Order, A10, 120VAC, 8-Button, Transmitter, Almond |
|
|
|
|
|
ACT TK284A Built to Order, A10, 208/240VAC, 8-Button, Transmitter, Almond |
|
|
|
|
|
ACT TK334A A10, 277VAC, Rocker Style, Transmitter, Almond (Special Order)Most of the wall-Mount units are stocked in White (W) and Ivory (I), however, "Almond" is usually only available in large quantities, special order. Call for quote and lead-time. |
|
|
|
|
|
ACT TK334I A10, 277VAC, Rocker Style, Transmitter, Ivory |
|
|
|
|
|
ACT TK334W A10, 277VAC, Rocker Style, Transmitter, White |
|
|
|
|
|
ACT TK384A Built to Order, A10, 277VAC, 8-Button, Transmitter, Almond |
|
|
|
|
|
ACT ZCS101 Z-Wave, Transceiver / Controller, RS232, Interface, N. Amer. w/120v p.s.New devices, replace ZCS0x0, must use 3rd party software. Call for details. |
|
|
|
|
|
ACT ZCS201 Z-Wave, Transceiver / Controller, RS232, Interface, Euro w/240v p.s.New devices, replace ZCS0x0, must use 3rd party software. Call for details. |
|
|
|
|
|
ACT ZCU000 Limited Supply, Z-Wave, Transceiver / Controller USB Interface, N. Amer. |
|
|
|
|
|
ACT ZCU101 Z-Wave, Transceiver / Controller, USB Amer. Interface, N. Amer. |
|
|
|
|
|
