Honeywell HPS3PM Power Supply/Battery Charger
The HPS3PM power supply/battery charger converts a low voltage AC input into an output of 12 VDC or 24 VDC @ 3.5 amps of continuous supply current (refer to specifications sheet). This access control power supply is power monitored with AC fail and low battery supervision (Form "C" contact relays).
Electrical Specifications
- Dip switch selectable for 12 VDC or 24 VDC output.
- Provides up to 3.5 amps of continuous supply current when using appropriate transformer and ventilated enclosure.
- Output is filtered and electronically regulated.
- Built-in charger for sealed lead acid or gel type batteries.
- Maximum charge current of 400 mA. If battery charger is used, subtract 400 mA from total output to determine allowable load.
- Automatic brown-out protection. Instantaneously switches to stand-by battery upon AC fail.
- Battery protected from short circuits.
- Thermal and overload protection with auto reset.
- LED indicators for AC input and DC output.
- Compact design (board dimensions: 7"L x 4"W x 1.75"H)
- Battery leads and foam mounting tape included.
- AC fail and low battery supervision (Form "C" relay contacts rated @ 5 amps, 30 VDC/120 VAC).
- Temperature Range: 32ºF to 120ºF (0ºC to 49ºC)
Note: Special order item. Non-returnable or subject to restocking fees.
|
|
|
| |
 |
|
|
