Macurco CM-1B Carbon Monoxide Detector: Stand-Alone or Remote Control
Description
CO detector for use as stand-alone detector or to control another device. Digital meter (0-250ppm), 2 relays, 85db buzzer, 12-24 VAC or VDC operation.
General Information
The CM-1B is a Carbon Monoxide (CO) Meter, Alarm and Controller. It is an all electronic system using a microprocessor to measure the concentration of CO and calculate the danger level, which is a combination of level of CO and time of exposure. The unit also has the ability to be calibrated in the field. See the CM-1B data sheet for more technical information.
Location
The unit on average can cover about 5000 sq. ft. The coverage depends on air movement in the room or facility. Extra detectors may be needed near any areas where people work or the air is stagnant. Normally, the unit mounts 5 feet above the floor, in a central area where air movement is generally good. See the CM-1B data sheet for more information on location.
Features
- Digital Display: Shows the current level of CO: 0-250 PPM
- Low Voltage Operation: Can be powered from most alarm control panels
- Power Supply: 120VAC UL listed power supply available
- Service: The CM-1B can be field calibrated
- Test Switch: The test switch provides a mode for the system to test itself
- Relays: Close at 35 PPM after 5 minutes and at alarm level
Specifications
- Power: 3 Watts
- Voltage: 10-26 VAC or VDC
- Size: 5" W x 6" H x 1¼" D
- Shipping Weight: 2 lbs.
- Color: Beige
- Alarm Sound Level: 85dB at 10 feet
- Alarm Relay Rating: 0.5 Amp, 200V, 10VA
- Alarm Setting: Equivalent to 10% CO in hemoglobin
- Accuracy: +/- 10% at 50 PPM CO
- Sensor Maintanance: Not required
-
Additional Information
|
|
|
| |
 |
|
|
