289-1 ETL Listed Pool Alarm - Closed Loop

ETL Tested To Be In Compliance With Standard for Safety, UL 2017, and Florida Building Commission Code Requirements, Per ETL Listing Number 3035022

289-2 ETL Listed Pool Alarm - Closed Loop

ETL Tested To Be In Compliance With Standard for Safety, UL 2017, and Florida Building Commission Code Requirements, Per ETL Listing Number 3035022.

289-3 ETL Listed Pool Alarm - Closed Loop

ETL Tested To Be In Compliance With Standard for Safety, UL 2017, and Florida Building Commission Code Requirements, Per ETL Listing Number 3035022

289-4 ETL Listed Pool Alarm - Closed Loop

ETL Tested To Be In Compliance With Standard for Safety, UL 2017, and Florida Building Commission Code Requirements, Per ETL Listing Number 3035022

The GRI Child Resistant Pool Alarm is designed to operate with either a 9 volt battery or external DC power supply. The surface and recessed models will operate at any DC voltage from 5 - 15 volts maximum. The 12 volt DC power threshold is recommended to keep the audible volume of the alarm at its maximum level.

The GRI Child Resistant Pool Alarm is designed to operate with either a 9 volt battery or external DC power supply. The surface and recessed models will operate at any DC voltage from 5 - 15 volts maximum. The 12 volt DC power threshold is recommended to keep the audible volume of the alarm at its maximum level.

The GRI Child Resistant Pool Alarm is designed to operate with either a 9 volt battery or external DC power supply. The surface and recessed models will operate at any DC voltage from 5 - 15 volts maximum. The 12 volt DC power threshold is recommended to keep the audible volume of the alarm at its maximum level.

The GRI Child Resistant Pool Alarm is designed to operate with either a 9 volt battery or external DC power supply. The surface and recessed models will operate at any DC voltage from 5 - 15 volts maximum. The 12 volt DC power threshold is recommended to keep the audible volume of the alarm at its maximum level.

GT10-2 Gate Mount Pool Alarm

The GT10-2 and GT10-4 can be operated independently with an on-board 9 volt battery or with a 12 volt externally supplied DC power source. Both power sources have been designed to maintain maximum sound pressure level, currently rated at 85 dB.

GT10-4 Gate Mount Pool Alarm

The GT10-2 and GT10-4 can be operated independently with an on-board 9 volt battery or with a 12 volt externally supplied DC power source. Both power sources have been designed to maintain maximum sound pressure level, currently rated at 85 dB.

May be hard wired to remote 12 volt maximum 500 mA source or to plug in power source. Applied voltage must not exceed 15 VDC

Features

• ETL Tested To Be In Compliance With Standard for Safety, UL 2017, and Florida Building Commission Code Requirements, Per ETL Listing Number 3035022
• Exceeds Operational Requirements of Model Barrier Codes
• Microprocessor Controlled
• Monitors Entry to Pool and Spa Areas
• Instant On or 7 Second Delay Models Available
• Surface or Flush Mount Models
• Remote Sounders and Shunt Options
• Built-in Back-up Battery Capable
• Low Battery Alert

WARNING: THIS IS NOT A LIFE SAVING DEVICE.

The GRI DPA-10 Series Pool Alarms operate on a 9 volt battery. U.L. requires that a Duracell alkaline battery Model MN1604 be used. Both units will operate at any voltage of 5-15 volts maximum. 12 volts is recommended to prevent sounder volume from dropping below minimum sound pressure levels of 85dB at 10’.

Features

• Monitors Entry to Pool/Spa Areas
• Listed per U.L. 2017
• Microprocessor Controlled
• Battery Operated
• Low Battery Indicator
• Exceeds Operational Requirements of Model Barrier Codes
• Surface Mount

The GRI DPA-10 Series Pool Alarms operate on a 9 volt battery. U.L. requires that a Duracell alkaline battery Model MN1604 be used. Both units will operate at any voltage of 5-15 volts maximum. 12 volts is recommended to prevent sounder volume from dropping below minimum sound pressure levels of 85dB at 10’.

Features

• Monitors Entry to Pool/Spa Areas
• Listed per U.L. 2017
• Microprocessor Controlled
• Battery Operated
• Low Battery Indicator
• Exceeds Operational Requirements of Model Barrier Codes
• Surface Mount