Cartell CF-2C Driveway System: Sound & Lights

This control unit with dual timed output includes floodlight control with full features. Field adjustments include: entry delay, floodlight time, exit delay, photocell sensitivity, re-trigger hold-off, annunciator time, probe sensitivity, and transient suppressor.

• Includes CA-5 plug-in transformer and FC-6 photocell daylight block.
• Use with CT-6 probe.
• Accommodates annunciators: FC-9, CT-8, CT-8A, CT-9A, CT-11.
• Case and circuit board may be purchased separately.
• CT-6 sensor probe with custom amount of direct burial cable attached (up to 3,000 feet)
• Annunciator: FC-9 (full function annunciator custom made for CF-2C), CT-8, CT-8A, CT-9A and/or CT-11; or you may use your own sounder.
• Stand-alone system where annunciation and lights are needed to alert that a vehicle is approaching. Integrate with security and home automation systems.
• Also activates CCTV, pager-transmitters, and transmitters.
• Use line carrier technology (X-10, Leviton, etc.) to avoid hard-wiring of lights.

• Covers 12 foot wide driveway when sensor probe buried beside drive
• Single-zone system
• Dual timed output
• 15 amp circuit operates up to 1800 watts of lights
• Accommodates 100 sensor probes
• Accommodates twelve annunciators
• Adjustable probe sensitivity
• Adjustable relay time
• Adjustable annunciator time
• Adjustable floodlight delay time
• Adjustable floodlight time
• Adjustable photocell sensitivity
• Adjustable FC-9 exit delay
• Manual trip test button
• Re trigger hold-off
• Transient suppression
• Built-in battery charger to use to power annunciators during power outage (battery not included)
• 12 volt transformer included
• Photocell light-block included (keeps lights from operating in daylight)

• Detects 100 locations
• Annunciates twelve locations
• Turns on up to 1800 watts of floodlights
• Acts as a trigger to activate transmitters
• Used with CT-6 probe, detects moving vehicles
• Used with CT-6 probe, protects stationary vehicles
• Used with CT-6 probe, signals security guard

Specifications

Power Required:	12 VAC or 12-15 VDC
Standby Current:	35 mA
Alarm Current:	180 mA max. with 1 FC-9 or 1 CT-8
Relay Contact Rating:	Double Pole, Double Throw
1st Pole:	12 VDC, 200 mA for remotes
2nd Pole:	SPDT, 5 amps, 30 VDC
Relay Time:	1/2 to 30 seconds
Floodlight Contact Rating:	SPST, 15 amp, 125 VAC CSA (1800 watts)
Floodlight Time:	15 seconds to 15 minutes
Floodlight Delay:	1 second to 2 1/2 minutes
Battery Charger:	13.5 VDC, 5 mA minimum charge (with voltage cut-off)
Temperature Range:	0º F - 140º F
Dimensions (complete unit):	7 1/2 in. x 12 3/4 in. x 3 in
Dimensions (board only):	7 1/4 in. x 4 1/4 in.
Weight (complete unit):	5 lbs