UDACT-F Digital Alarm Communicator Transmitters (DACT)

The UDACT-F is compact in size and may be mounted inside the host control panel or may mount externally in a separate cabinet. EIA-485 annunciator communications bus and regulated 24-volt connections are required. The UDACT-F transmits 198 points or 56 zones when connected to the MS-9200, up to 636 points or 98 zones when connected to the MS-9600, and 56 zones when connected to the Sensiscan 2000.

The Fire•Lite UDACT-F Universal Digital Alarm Communicator Transmitter may be used on the MS-9200, MS-9600 and Sensiscan 2000 Fire Alarm Control Panels (FACPs). The UDACT-F transmits system status to UL listed Central Station Receivers via the public switched telephone network.

• Four supervised monitoring channels (inputs): three fixed Style B (Class B) and one Style A (Class A) or Style B (Class B).
• Inputs may be individually programmed for standalone applications, or when monitoring a host control panel, for:
  – Two- and four-wire smoke detectors (Inputs 1 and 3)
  – Pull station
  – Normally-Open contacts
  – Host panel trouble (slave mode)
  – Supervisory
  – Supervisory (autoresettable)
  – Waterflow (silenceable)
  – Waterflow (non-silenceable)
  – Process monitoring
  – Process monitoring (autoresettable)
• One Style Y (Class B) Notification Appliance (bell) Circuit (NAC)
• 10 Amp notification appliance power
• Coded (temporal) notification appliance (bell, signal) circuit
• 12 VDC operation
• Capable of 60 hours of standby
• Seven individual LEDs; six visible through door:
  – AC Power
  – System Trouble
  – System Alarm
  – Supervisory
  – Communication Fail
  – Battery Trouble
  – Earth Fault (not visible with door closed)
• Dual telephone lines:
  – Dual telephone line voltage detect
  – Alternating phone lines for 24-hour test messages (programmable)
• Industry-first, UL recognized, "dialer runaway" prevention feature

• Datasheet