The 2W-MOD2 is a two-wire loop test and maintenance module for use with i3 Series detectors. (Replaces Model No. 2W-MOD)
The A77-AB Adapter Bracket allows installers to retrofit applications where a larger diameter detector was previously installed.
The A77-AB2 allows installers to retrofit i3 Series detectors where a larger diameter detector was previously installed.
The B110LP is a 2-wire base for use with 100 Series smoke detectors.
The B110RLP is a 2-wire base for use with 100 Series smoke detectors.
The B112LP is a 4-wire base with Form A&C relay contacts, for use with 100 Series smoke detectors.
The B114LP is a 4-wire base with Form A&C and Form A Supervisory relay contacts, for use with 100 Series smoke detectors.
The B116LP is a 2-wire base with a Form C relay contact, for use with 100 Series Smoke detectors.
Heating kit for use with the transmitter/receiver unit of System Sensor reflective projected beam smoke detectors
Heating kit for use with the reflector of System Sensor reflective projected beam smoke detectors
End-of-line epoxy encapsulated (SPST) relay
The MOD400R is used to check the sensitivity of System Sensor 100, 200, 400, and 500 Series smoke detectors, and DH100, DH200, DH400, and DH500 Series duct smoke detectors.
Epoxy encapsulated (SPDT) relay with activation LED
Single (SPDT) relay with activation LED
4-gang (SPDT) relay with 4 activation LEDs
Single (DPDT) relay with activation LED
4-gang (DPDT) relay with 4 activation LEDs
The RA400Z is a remote annunciator for use with both conventional and intelligent smoke detectors.
The RMK400 Recessed Mounting Kit is for use with System Sensor 100, 200, 400, and 500 Series plug-in detectors.
The RRS-MOD is a reversing relay/synchronization module for use with i3 Series detectors with built-in sounder.
The RT is an installation/removal tool for use with i3 Series detectors.
The SENS-RDR is utilizes infrared technology to read the sensitivity of i3 Series detectors.
The SMB600 flanged surface mounting kit may be used with certain System Sensor smoke detectors when flush or recessed mounting are not possible.
The SMK400 flangeless surface mounting kit may be used with certain System Sensor smoke detectors when flush or recessed mounting are not possible.
The XR2 is an installation/removal tool for use with 100 and 200 Series plug-in smoke detectors.
